iFoam

The iFOAM Laboratory Foam Bitumen Plant is designed to be professional equipment as a true representation of "Asphalt Foaming", a professional-grade equipment for indoor study of foamed asphalt.
iFOAM supported use of the mixer can be used for cold mix materials, but also for hot mix (warm mix) materials.

The patented foamed bitumen generator, core component of iFOAM has a function of secondary foaming, the rationary design makes the mixing of asphalt and water more evenly, so as to the asphalt foaming process more fully and foaming effect more better. In addition, an increase of some regulatory function is used to optimize the foaming properties of asphalt.
iFoam asphalt tank comes with an agitator, to ensure consistent temperature of asphalt tank from top to bottom. iFoam asphalt tank ergonomic height above ground makes the dumping asphalt work more convenient and safe.
All iFoam bitumen pipes have heat insulation function, to avoid clogging the asphalt, eliminating lines clean.

TECHNICAL PARAMETERS

Water consumption: Min: 2.5L/Hour; Max: 6.0L/Hour
Air consumption: Min: 0L/Hour; Max: 100L/Hour
Max bitumen pump pressure: 2.5Mpa
Max water pressure: 0.6Mpa
Air pressure: Min: 0.4Mpa; Max: 0.6Mpa
Water Temperature: Min: 10°C; Max: 60°C
Bitumen temperature: Min: 140°C; Max: 200°C
Bitumen tank volume: 12.5L
Power supply voltage: 220V
Water tank volume: 6L
Air chamber Volume: 6L
Rated power: Bitumen pump: 1.5kW; Heaters: 3.2kW; Control: 0.1kW
Bitumen pump speed: Min: 1Hz; Max: 60Hz
Power supply voltage: 220V
Asphalt foam spraying time can be set: 0.1-999S
Dimension (length*width*height): 1261x670x1200mm

Brochure.pdf

Air pressure adjusting valve
Water pressure adjusting valve
Air pressure gauge
Temperature controller
Frequency converter
Water pressure gauge
Hight pressure water pressure gauge
Touch screen
Emergency stop for asphalt pump
Switch
Water filling nozzle (ball value)
Air inlet
Water flow meter
Asphalt tank cover
Pressure gauge of asphalt pump
Asphalt bucket support board
Content gauge