TPC-15W/TPC-20W/TPC-25W
Wheel type CPT vehicle uses hydraulic transmission system to penetrate, anchor, level and lift car body, etc.
The hydraulic system's oil is supplied by a large flow and high-pressure gear pump with an advanced directioncontrolling combination multi-way valve which is installed in the console center. Each a hydraulic valve controls one circuit. On the right of multi-way valve, the relief valve is installed to control the oil pressure.
Wheel type CPT vehicle uses hydraulic transmission system to penetrate, anchor, level and lift car body, etc.
The hydraulic system's oil is supplied by a large flow and high-pressure gear pump with an advanced directioncontrolling combination multi-way valve which is installed in the console center. Each a hydraulic valve controls one circuit. On the right of multi-way valve, the relief valve is installed to control the oil pressure.
The operation panel has two layers. The upper is the main control circuit while the lower is oil cylinder control circuit. On the upper layer there are three control rods: the left one to control penetration system; the middle one to control the anchor system; the right one to control the hydraulic props. The lower four rods is to control oil cylinder.
TECHNICAL PARAMETERS
Engine type: Diesel CZ2100
Max speed: 40KM/h
Max force: 150kN, 200kN, 250kN
Drive: Diesel Engine, Electric starting
Oil pressure: 10 Mpa
Penetration speed: 1.2±0.3m/min
Dimension(m): 3.1×1.6×1.63
Weight: 3000Kg
Operation part
TPCL-001A Operation system 1set
TPCL-001C Vehicle (20t) 1
Penetration part
TPCL-002A Penetration cylinder 1set
TPCL-002B Penetration rod(ø40) 50
Anchoring part
TPCL-003A Hydraulic anchor machine 1set
TPCL-003B Ground anchor 6sets
TPCL-003C Anchor fixing beam 2
TPCL-003D Wedge key on anchor tip 10
TPCL-003E U-shaped heave device 1set
Accessories
TPCL-004A Fixing block 2
TPCL-004B Reducer union 1
TPCL-004C Guide sleeve(ø40) 1set
TPCL-004D Tool 1set
TPCL-004E Gasket 1set
TPCL-004F 8 core cable 80m
